Blog

Sticking Valves Because Of Carbon Deposits And Rich Fuel Mixture

12/12/2025

The first sign of sticking valves is usually, engine misfires or running rough when cold. However, sticking valves can also be, the byproduct of cold weather operation. In this case, the sticking valves will often […]

Reduced Engine Power Warning Light – What To Do And Why?

12/07/2025

Reduced Engine Power, can have many different names. All depending on the year, make and model of your vehicle. So, whether its, reduced engine power, limp mode, fail safe mode or limp home mode, they […]

How To Do A Cylinder Leak Down Test – With Or Without A Tester

12/02/2025

Doing a cylinder leak down test, can tell you more about your engine than you think. Also, it can spot issues in specific areas, that other tests will not. So, a cylinder leak down test, […]

Check Engine Light (CEL) – What Can Cause It To Come On

11/28/2025

Seeing a Check Engine Light (CEL), is one of the most frustrating and confusing factors of owning a vehicle. So, the (CEL) is just a light, with no information. It tells you that there is […]

Cylinder Head Cracking – Overheating Is The Most Common Cause

11/24/2025

Cylinder head cracking can cause catastrophic damage to your engine. In some cases the crack may be so severe, that replacing the whole engine is the only cure. But most of the causes are all […]

Fuel Pump Issues – Excessive Heat – Contamination, Dirt, Rust

11/19/2025

The fuel pump should deliver fuel from the fuel tank to the engine; at the appropriate pressure. Fuel pumps on most modern vehicles are electric and are mounted in the fuel tank. However, older ones […]

Vacuum Leaks – How To Quickly Find Them In 5 Easy Steps

11/14/2025

Vacuum leaks in today’s computer controlled engines, can cause very serious engine damage. When an engine that has computer controlled spark and fuel systems, have vacuum leaks, the following events occur. Because, these leaks pull […]

Repeat Engine Failures From Not Diagnosing The Original Problem

11/09/2025

The installer’s worst nightmare, repeat engine failures from not diagnosing the original problem. So, you have replaced an engine, cylinder head, or crankshaft in your car. But a short time later you have a repeat […]

Cylinder Head Resurfacing – Getting The Correct Surface Finish

11/05/2025

Cylinder head resurfacing is a very common process today, especially with all the leaking head gaskets. Above all, cylinder head resurfacing is the most common machining operation, done in machine shops to date. However, many […]

Valve Guide Wear – How to Identify and Reduce Oil Consumption

10/25/2025

Valve guide wear, refers to excessive clearance, between valve stem and guide. As the guide wears, the side to side movement, can cause valves to seat improperly. As a result, requiring you to need a […]